Installation Kit
This is an installation kit to wire up motors and the gear selector, it includes:
10 feet of 10AWG wire rated for 30A of current
6 Wago lever nuts rated for 30A each (2 for battery input, 2 for left motor and 2 for the right motor)
4 different colored solid core jumper wires 2 feet long each for extending the direction selection input wires
2 dual position lever nuts for extending gear selection wires
This kit should be enough to run a single battery wire to the motor controller and connect both motors to the motor controller in most ride on cars. If the motor controller is going in the front where two long runs to the rear motors are required, additional 10AWG wire may be required.
This is an installation kit to wire up motors and the gear selector, it includes:
10 feet of 10AWG wire rated for 30A of current
6 Wago lever nuts rated for 30A each (2 for battery input, 2 for left motor and 2 for the right motor)
4 different colored solid core jumper wires 2 feet long each for extending the direction selection input wires
2 dual position lever nuts for extending gear selection wires
This kit should be enough to run a single battery wire to the motor controller and connect both motors to the motor controller in most ride on cars. If the motor controller is going in the front where two long runs to the rear motors are required, additional 10AWG wire may be required.
This is an installation kit to wire up motors and the gear selector, it includes:
10 feet of 10AWG wire rated for 30A of current
6 Wago lever nuts rated for 30A each (2 for battery input, 2 for left motor and 2 for the right motor)
4 different colored solid core jumper wires 2 feet long each for extending the direction selection input wires
2 dual position lever nuts for extending gear selection wires
This kit should be enough to run a single battery wire to the motor controller and connect both motors to the motor controller in most ride on cars. If the motor controller is going in the front where two long runs to the rear motors are required, additional 10AWG wire may be required.
